You are here
Tooling
Tooling, fixtures and jigs/work holding...
| Title |
Post Date |
Last Activity |
|---|---|---|
| 30 Deg thread block and bar replacement. | Mon, 03/18/2013 - 02:57 | Sun, 12/14/2014 - 14:20 |
| MT3 Center Drill Holders | Mon, 04/22/2013 - 17:20 | Sun, 10/30/2016 - 02:00 |
| Turret for Cross-Slide | Sat, 04/27/2013 - 19:18 | Sun, 12/14/2014 - 14:20 |
| Sliding tap holder for tail-stock | Sat, 05/04/2013 - 06:12 | Fri, 06/02/2017 - 23:08 |
| Gear Cutter ( multi-tooth ) | Sun, 06/09/2013 - 21:11 | Sun, 12/14/2014 - 14:20 |
| Off center arbor for making a multi-tooth gear cutter | Mon, 06/10/2013 - 05:47 | Thu, 01/01/2015 - 19:40 |
| Squaring the Body of a 3" Drill Press Vise | Fri, 11/29/2013 - 06:16 | Sun, 12/14/2014 - 14:20 |
| Pneumatic air piston for table saw sled controlled by an Arduino | Mon, 12/21/2015 - 00:49 | Wed, 05/04/2016 - 00:18 |
| Swivel and Pivoting base for a 5C Collet Spin Indexer (Spindexer) | Thu, 04/14/2016 - 23:28 | Wed, 05/03/2017 - 12:39 |
Random Site Links
- 24xx256 - 256K I2C CMOS Serial EEPROM chip
- MINI NC Controller for Z-axis: 4x4 Matrix Keypad
- Swivel and Pivoting base for a 5C Collet Spin Indexer (Spindexer)
- Albert Einstein Quotes
- Delivered and un-created
- Squaring the Body of a 3" Drill Press Vise
- Turret for Cross-Slide
- Vase: maple zig-zag dyed red
- Anais Nin Quotes
- PCF8574 and PCF8574A I2C Address Map
