You are here
Nook HD+ Stand
Post date:
Wednesday, October 30, 2013 - 07:15
Last modified:
Sunday, December 14, 2014 - 14:20
Wanted a stand for my Nook HD+ which would let me stand the Nook up vertical while plugged in (charger or USB).
Made from aluminum and brass.
All the "knobs" are 3/8-16 and knurled. The font two knobs which hold the Nook inplace screw into two threaded sleeves 1/2-20 x 3/8-16 and made from 1018; figured they would get the most use and did not want to beat up on or wear out the aluminum (which was around 3/16 thick).
So far so good, no complaints yet.
Image Gallery:
Mobile QR Barcodes:
Save Article as PDF | Current URL Address |
<br />Other site pages which link here:<hr />
Category:
Save page as PDFRandom Site Links
- The resurrection of a Greenerd 3 1/2 Ratchet Arbor Press
- Pair of clamps for a boat seat frame.
- 30 Deg thread block and bar replacement.
- Raising mill off its base with 4x4 box tubing
- Drawers Under Mill
- Toshiba mouse pad scroll, single finger.
- Delrin 120 idler gear
- Anais Nin Quotes
- MINI NC Controller for Z-axis: Stage One
- MINI NC Controller for Z-axis: Stage Two (Panel & Drill Cycle)
Add new comment