Not big on change overs/tool changes, if i can find a short cut, normally ill give it a shot, so i made up six (really seven, but one came out alittle short) MT3 blanks which will find some kind of use down the road.
4# center drill is my go to for center drilling for tail-stock live center use so a dedicated holder seamed like a good idea.
Currently both of my drill chucks are 1/2", which is too small for the 5/8 shank on a 7# center drill so that will go in the shorter blank (not that i will use the 7# center too much, but while i was at it figured i would make a holder for it).
End result:
Save Article as PDF![]() | Current URL Address![]() |
Comments
Looks good. I like the idea
Looks good. I like the idea of making all the blanks at a single sittings. Thanks for the idea.
Glad you like it.Not that
Glad you like it.Not that setting up the tail-stock is a big deal, but once its set, it does make the rest of the blanks a 1-2-3 job even if you do not have any immediate plans for them.
Great! How did you get the
Great! How did you get the blanks to be so shinny in the top right pic, next to your tool box ?
Used emery paper; 220, 320
Used emery paper; 220, 320 then stich brite (gray, thats what i had for woodworking). The finish from the tool was not too bad, did not have to do alot of work to get them smooth... They are not like ground and polished, but they are pretty good.
Great post
One thing I do for multiples is use a round faceplate with four ‘sides’ added to it to trap and center the rosette block. Then a center screw in from the back will hold the blank in place, and the sides keep it from spinning.
Add new comment